International 4300 Dt466 Wont Start - Got an 01 int 4900 with a dt466 ht with a crank no start with no attempt to even try firing up. Will run on spray. Narrowed it down to #5 injector. Replaced injector, put new orings on hipop. It will not start. This truck has been haunting me for months: Bdh 2006 international dt466 truck wont crank turn the key nothing all the relays click, the only thing i hear when i\i turn the key is. Have a 2003 international 4300 with the dt466, 50k miles. Truck has been sitting most of the winter, and i have been starting it every month or so to keep things fresh. 2 weeks ago the truck would crank very very slowly, i could not drive the truck to the shop as it would not start. Took the batteries to local parts store to get checked. Got a 05 4300 towed into shop cranks wont start,whats been done so far is scan for codes no codes active only 1 inactive for brake switch. check eng light self checks, all fuses. Egr valve may be stuck open. This could cause a no start. Fuses at the battery box for ecm and idm. Check the ipr connector. Make sure terminals are not too spread and. Tonight it would not start with primer, no leaks detected. There is a 2 wire plug that connects to a brass colored piece close to the high prssure braided hose that carries oil to the. I'm working on a 2002 international 4300 with a dt 466e engine. The engine won't crank over at all and when i jump the starter solenoid to get it running the throttle pedal is. Had only about 10psi oil pressure cranking hot and 400 on the high side. Hit it with ether and it speeds up and starts so i changed the lpop and it starts a little better cold but not.
Got an 01 int 4900 with a dt466 ht with a crank no start with no attempt to even try firing up. Will run on spray. Narrowed it down to #5 injector. Replaced injector, put new orings on hipop. It will not start.